EasyManua.ls Logo

Korg microKORG2 - Effect Type

Korg microKORG2
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
microKORG2 EFFECT, EQ section - Modulation (MOD)
98
|
Effect Type
Chorus
Chorus is an effect created by modulating a delay to change the pitch of a signal. Mixing the modu-
lated signal with the unmodulated signal creates an imitation of the slight (or not so slight) differ-
ences in intonation between two musicians playing in unison, while the modulated signal on its own
can be used as a vibrato.
MOD
1. Effect Type (Type) Chorus
2. Chorus Sub Type (SubTy pe) [Stereo, Light, Mono, Vibrato, Manual]
Selects one of the available sub types.
3. Speed [0...127] (CC#12)
Adjusts the rate of the modulation effect, depending on the range of the selected subtype. Turning
the knob to the right will increase how fast the effect modulates the input signal.
Note:
When the “Manual” sub-type is selected, the Speed parameter won’t change the sound, as the
internal LFO is stopped.
4. Depth [0...127] (CC#111)
This sets the intensity of the effect. Turning the knob to the right will increase the intensity.
MOD EXTRA
1. Low Cut (LowCut) [0...127]
Adjusts the cutoff frequency of the high-pass filter. Turning the knob to the right will reduce the
amount of low frequency sound.
2. Manual [0...127]
Adjusts the delay offset of the effect. Turning the knob to the right increases the offset.
3. Width [0...127]
Sets the stereo spread of the effect. Turning the knob to the right will increase the width of the stereo
field.
5. Dry/Wet [0...100 %]
This sets the mix of the unprocessed (dry) and processed (wet) signals. Turning the knob to the right
will increase the wet level and decrease the dry level.
Flanger
An effect that produces an intense undulating effect.
MOD
1. Effect Type (Type) Flanger
2. Flanger Sub Type (Sub Type) [Stereo +, Stereo -, Light +, Light -, Mono +, Mono -, Manual]
Selects one of the available sub types.
3. Speed [0...127] (CC#12)
Adjusts the rate of the modulation effect, depending on the range of the selected subtype. Turning
the knob to the right will increase how fast the effect modulates the input signal.

Table of Contents

Related product manuals