Korg microKORG2

To Next Page

To Previous Page

microKORG2 EFFECT, EQ section - Modulation (MOD)

4. Depth [0...127] (CC#111)

This sets the intensity of the effect. Turning the knob to the right will increase the intensity.

MOD EXTRA

1. Low Cut (LowCut) [0...127]

Adjusts the cutoff frequency of the high-pass filter. Turning the knob to the right will reduce the

amount of low frequency sound.

2. Manual [0...127]

Adjusts the delay offset of the effect. Turning the knob to the right increases the offset.

3. Width [0...127]

Sets the stereo spread of the effect. Turning the knob to the right will increase the width of the stereo

field.

4. Feedback [-63...0...63]

Sets the amount of the output signal that will be routed back to the input of the effect, creating

intense resonant peaks. Turning the knob to the right of center will increase the amount of feedback,

while turning the knob to the left of center will increase the amount of feedback and invert the phase

of the feedback, shifting the resonant peaks.

5. Dry/Wet [-100...0...100 %]

This sets the mix of the unprocessed (dry) and processed (wet) signals. Turning the knob to the right

of center will increase the wet level and decrease the dry level, while turning the knob to the left of

center will increase the inverted wet level and decrease the dry level.

Ensemble

A rich chorus-like effect.

MOD

1. Effect Type (Type) Ensemble

2. Ensemble SubType (SubType) [Stereo, Light, Mono]

Selects one of the available sub types.

3. Speed [0...127] (CC#12)

Adjusts the rate of the modulation effect, depending on the range of the selected subtype. Turning

the knob to the right will increase how fast the effect modulates the input signal.