microKORG2 EFFECT, EQ section - REVERB
108
REVERB
The reverb effect is used to create the impression of playing in a space. This effect is produced by
combining the sound of multiple sonic reflections that occur at different times.
•
Press the REVERB button while holding down the ON/OFF button to turn the effect on/off (the LED below
the button lights up when the effect is on).
•
Press the REVERB button to access the related parameters (the button blinks). Use the EDIT CONTROL 1–5
knobs and the FUNCTION 1, 2 buttons to set the value.
•
Long-press either the MOD, DELAY or REVERB button to access the EFFECT ROUTING page, where you
can set the effect to which each timbre and the mic audio is sent.
→ EFFECT ROUTING
•
Use the Effect Type parameter (knob 1) to select the effect type. The parameters shown below (knobs 2–5)
depend on the effect type.
|
REVERB
1. Effect Type (Type) [Hall, Room, Spring, Rust, Pitch Shift, LoRes]
Selects the effect type.
2...5. Effect Parameters
This configures the parameters of each effect.
For more on the parameters, refer to the explanations for each effect type.
|
REVERB DETAILS
1...5. Effect Parameters
This configures the parameters of each effect.
For more on the parameters, refer to the explanations for each effect type.
To Next Page
Loading...
