Korg microKORG2 - Amp Eg, Filter Eg; Amp Eg

microKORG2 TIMBRE EDIT section - AMP EG, FILTER EG
64
AMP EG, FILTER EG
| AMP EG
Here you can configure the AMP EG, which applies time-variant change to the volume.
Create the desired volume curve by adjusting the ADSR parameters: Attack [1], Decay [2], Sustain [3]
and Release [4].
1. Attack [0...127] (CC#73)
Sets the time from note-on (when the key is pressed) until the attack level (maximum value of the
envelope) is reached.
2. Decay [0...127] (CC#75)
Sets the time from when the attack level is reached until the sustain level (SUSTAIN) is reached.
3. Sustain [0...127] (CC#70)
Sets the volume that’s maintained after the decay time has elapsed, as long as you continue holding
the key.
4. Release [0...127] (CC#72)
Sets the time it takes from note-off (when the key is released) until the level reaches 0.
5. Velocity Sens (Velocity) [0...127] (CC#79)
Controls the amplitude of the EG according to the velocity at which you play the keys.
Increasing this value makes the amplitude more responsive to the velocity (how hard or soft you
play). With a setting of 0, velocity does not affect the amplitude.