microKORG2 LOOP RECORDER section - LOOP RECORDER
114
LOOP RECORDER
The loop recorder is used to record and play back the microKORG2’s audio, as well as audio from a
mic or from the AUX IN.
|
REC, PLAY/STOP
When the loop recorder is stopped, press the button to enter record standby and the button
to start recording. Also, when the loop recorder is stopped, press the button to begin playback
and the button to start recording.
You can also long-press the or buttons to access the LOOP SETTING A/B pages, which con-
tain the loop recording and playback settings.
|
Undo/Redo
Press the button to undo or redo an operation. This lets you undo the previous recording.
Long-press the button to erase the audio data.
To Next Page
Loading...
