microKORG2 Playing the microKORG2 - Using the vocal processors
33
|
Using the harmonizer
This shows how to shift the pitch of your vocals and add that voice as a harmony to the original
vocals for output.
1 Press the HARMONIZER button while holding down the ON/OFF button to turn the harmonizer
on/off.
The HARMONIZER ON/OFF LED lights up when the harmonizer is on.
2 Now, sing into the mic (when Scale/KBD on the VOCAL SETTING page is set to “Scale”).
You can also sing while playing the keyboard (when Scale/KBD on the VOCAL SETTING page is set
to “Keyboard”).
Adjusting the harmonizer
1 Press the HARMONIZER button to show either the HARMO A page or the HARMO B page (the
HARMONIZER button blinks).
2 Use the EDIT CONTROL 1–5 knobs to set the parameters. → HARMONIZER
|
Adjusting the mic input/output
On the EDIT GLOBAL MIC page, you can adjust how much noise is cut with there is no input from the
mic, as well as the input/output response time. → MIC
To Next Page
Loading...
