microKORG2 Part names - Display
19
SCOPE: Shows the oscilloscope.
WRITE: Saves the current program. Press this button to show the rename, save program and cancel
menu options. → Writing a program
FUNC/HOME: Hold down the FUNC (FUNCTION 5) button to access the remaining functions.
→ Functions
After you press a button such as TIMBRE EDIT, the FUNCTION 5 button becomes the HOME button.
Press the HOME (FUNCTION 5) button to access the home page.
|
Edit page
Use the respective pages to make detailed edits to the OSC, EG, LFO, effects and so on.
1 Press the respective buttons in the following sections to show each edit page.
TIMBRE EDIT, EDIT, VOCAL PROCESSOR, EFFECT, EQ
Long-press: TIMBRE [TIMBRE MIX], VOCAL PROCESSOR [VOCAL SETTING], EFFECT [EFFECT
ROUTING], , [LOOP SETTING A, B]
2 If there are multiple pages, pressing a button multiple times will cycle through them (a tab
indicating the currently selected page will appear at the top of the display).
Tip:
The pages switch in reverse order while you are holding down the HOME (FUNCTION 5) button.
3 Use the EDIT CONTROL 1–5 knobs to increase or decrease the parameter values. Use the INC and
DEC buttons to increase or decrease the values by one step.
To Next Page
Loading...
