microKORG2 TIMBRE EDIT section - LFO 1, 2
68
3. Frequency (Freq) [“Mode” Tempo: 1/1, 1/2, 1/3, 1/4, 1/6, 1/8, 1/12, 1/16, 1/24, 1/32 / “Mode” Free,
OneShot: 0...127] (CC#90)
Sets the frequency of the LFO.
When Mode is set to “Tempo”: This sets the LFO cycle to a ratio of the tempo. The set value (note
length) in relation to the tempo equals one LFO cycle. For instance, a setting of 1/4 makes one beat
equal to one cycle.
When Mode is set to “Free” or “One Shot”: This sets the LFO frequency. Increasing this value results
in a faster frequency.
4. Key Sync/Key Trigger [“Mode” Tempo, Free: Off, Timbre, Voice/“Mode” OneShot: Timbre, Voice]
Specifies whether the LFO phase is reset when a note-on occurs for that voice (meaning when you
play a key).
“Key Sync” (when Mode is set to “Tempo” or “Free”)
Off: The LFO phase is not reset when a note-on occurs.
Timbre: The LFO phase is reset at the first note-on that occurs while no keys are pressed. The same
phase is used for modulating all voices that are triggered by a note-on afterwards.
Voice: The LFO phase is reset at each note-on, and each voice that plays uses its own LFO phase.
“KeyTrigger” (when Mode is set to “OneShot”) [Timbre, Voice]
Timbre: see “Timbre” in Key Sync.
Voice: see “Voice” in Key Sync.
5. Smooth [0...127] (CC#91)
Smooths out the motion of the LFO.
To Next Page
Loading...
