26| The Piano
Using the effects
The effects
You can select the various effects and amp models by turning the corre-
sponding TYPE knobs. You can change the effect settings by using the
DEPTH, INTENSITY, SPEED, DRIVE knobs. If you press the knob, the original
value of the parameter will be recalled. Deeper editing can be done through
the SV-2 Editor software.
Effects and the amp simulation can also be turned on or off by pressing the
corresponding On/Off button. Changes can be saved, together with a sound,
into one of the FAVORITES locations.
We will experiment with the effects, by going from the beginning of the effect
chain, where the most mind-boggling stompbox effects are located, to the
end, with the creamiest, most reassuring touch-up effects are contained. Just
consider this effect chain as the effect chain of a classic instrument amplifier.
SIGNAL ROUTING
EQ PRE FX
MODULATION AMBIENT TOTAL FX
Stereo Limiter
Stereo Mastering Limiter
OUTPUTS
SOUND
PRE AMP
VOLUME VOLUME POWER
AT T.
PROGR
LV L
POWER AMP
VALVE
CABINET NR
NOTE: With some of the effects, the name of the actual parameter you will be editing may
differ from what is printed on the piano panel. The name that appears in the SV-2 Editor
is the real name, as reported in the following tables. E.g., with the Pre FX Compressor, the
SPEED and INTENSITY knobs control the Sensitivity and Level parameters respectively.
To Next Page
Loading...
Need help?
General
