Editing workflow |59
English
Editing workflow
While it is very easy to understand how to use the SV-2 Editor, and you are
free to use the editing procedures that you prefer the best, please carefully
follow these steps to connect the SV-2 to a computer and to transfer data
between them.
1 Connect your SV-2 to your computer using an USB cable.
2 Turn the SV-2 on.
3 Launch the SV-2 Editor, and wait for the content of the SV-2’s memory to be
transferred into the Editor, and appear in the side drawer.
Also, you can load data saved on disk (this might be data you edited in the
past, or that you download from the web).
4 Go to the Sound, FX or Global page and edit your data.
Changes are immediately mirrored to the SV-2, so that you can listen to them
when playing the keyboard. However, they are not saved into the SV-2 mem-
ory.
5 Click the Write Favorite button in the side drawer to save the changes into
the SV-2’s memory.
6 If you want to create a backup set with all the edited data, click the Backup
All Data button in the side drawer.
A Save dialog appears. Enter a name for the new backup set, choose a place
where to save it in the disk, then confirm.
7 Exit from the SV-2 Editor.
8 If you want, disconnect the USB cable.
9 Enjoy your new sounds!
To Next Page
Loading...
Need help?
General
