Running SV-2 Editor |53
English
Running SV-2 Editor
Connecting your SV-2 via USB
Before using the SV-2 Editor, you must connect your SV-2 to a personal com-
puter via a standard USB cable.
Please note that not all USB hubs are compatible with SV-2. In case you ex-
perience troubles when connecting the piano to your computer, remove the
hub and directly connect the piano to an USB port of your computer.
Turning your SV-2 on
For all the features of the SV-2 Editor to work, the SV-2 must be connected
and turned on before you run the software. Otherwise, only the Backup page
will be available to manage your backup sets.
The computer or the SV-2 may enter sleep mode while using the editor, and
connection between them may be interrupted. In this case, please wake
them, then exit and relaunch SV-2 Editor. You may set your computer and
SV-2 so that they don’t go to sleep while working with the SV-2 Editor.
Also, please note that your computer might exit from sleep mode when you
turn the SV-2 on. This is a normal behavior, since the USB port is sensing the
SV-2 returning to an active state.
Launching SV-2 Editor
Locate the application’s icon into your hard drive, and double click it.
To Next Page
Loading...
