Advanced settings |37
English
Adjusting the program levels
Some Sounds can be made of up to three programs, whose volume level you
can adjusts as you like.
1 Press the FUNCTION button.
After you press this button, one of the LEDs around each of the knobs in the
EQUALIZER section starts blinking. If a program is in mute, no LED can be
seen around the corresponding knob.
2 Use the knobs to edit the program levels. The LEDs around the knob show
the nearest value of the program’s volume.
3 By pressing a knob, the original value will be recalled. If you want to recall
the original value, select the same factory or favorite sound again.
4 By keeping a knob pressed for about one second, the corresponding pro-
gram is turned on or off (muted).
NOTE: The program levels are memorized when saving a favorite sound.
Changing the split point
You can change the split point, that is the note where the keyboard is divided
between different timbres. When you save the changes into a favorite sound,
the split is saved with it.
Please note that you can switch from a layered to a splitted sound, and vice
versa, by using the SV-2 Editor.
1 Keep the LOCAL OFF button pressed for about one second, until its LED
starts blinking.
2 Press the note corresponding to the desired split point. The split point will be
changed, and the LED will turn off.
If no note is played after some seconds, the split programming will end.
NOTE: The split point is memorized when saving a favorite sound.
To Next Page
Loading...
Need help?
General
