32| The Piano
Saving or resetting the
changes
Recalling the original settings
Each time you move a knob, its value is changed. Press the same knob to
recall the original value for the corresponding parameter.
To recall the default value of a parameter, select the effect type again to
reset all its parameters.
To recall all the default parameters, select the sound again, and all the ef-
fects and parameters will be reset.
Switching to a different sound or effect
while editing
When selecting a different effect in a section, all changes to the previous
effect are preserved. You can return to the edited effect, and all changes
will still be there. (In case you want to return to the original value, press the
corresponding parameter’s knob).
On the contrary, when you select a different factory or favorite sound, all
parameters are reset and changes are lost.
Saving the changes to a sound
If you like the sound you just created by exploring through the knob posi-
tions, save it as a favorite sound.
1 Press the TYPE knob to see which bank of favorites sounds is selected.
The currently selected bank is shown by the FAVORITES (A‑H) button that
is blinking.
2 If you want to select a different bank, press the FAVORITES (A‑H) button
corresponding to the bank to be selected.
3 Keep pressed the FAVORITES (1‑8) button corresponding to the favorite
where you want to save your settings, until its LED starts blinking.
To Next Page
Loading...
Need help?
General
