Korg SV-2 User Manual

FX page |95
English
Ambient Effects section
Here you can adjust the settings of a reverb, echo or delay effect inserted
after the modulation.
Choosing an Ambient effect
Click the name of the selected Ambient model, then choose a different item
from the list.
Room
This models the reverberation of a typical room, with numerous early reflec-
tions.
Parameters Values Notes
Time 0…99 Sets the reverb time.
Lo Damp 0…100 Adjusts the attenuation of the low-frequency range.
Hi Damp 0…100 Adjusts the attenuation of the high-frequency range.
Pre Delay 0…70 Sets the initial delay before the reverberation begins. By
adjusting this setting you can clarify the definition of the
original sound.
Mix 0…100 Adjusts the mix between the direct signal and the effect.

Korg SV-2 Specifications

General

Polyphony	128 voices
Sound Engine	PCM
Keyboard	88-key RH3 (Real Weighted Hammer Action 3)
Effects	Reverb, Delay, Chorus, EQ, Amp Simulator
Amplifier	Built-in stereo amplifier
Connections	MIDI In/Out, USB
Power Supply	AC adapter (included)