kruss K11 MK3 - Page 114

page 112 Appendix
O
oscillating period............................................72
P
password .......................................................75
plate method
detection speed speed............................................42
filling level................................................................36
immersing speed.....................................................41
immersion depth......................................................42
interfacial tension ....................................................44
interval.....................................................................40
main menu...............................................................39
measuring mode......................................................39
parameters in the setup ..........................................41
reading limit.............................................................40
surface tension........................................................43
power supply .................................................14
preparations
check list..................................................................38
print setup......................................................77
protection.......................................................77
pull ...........................................................48, 56
push.........................................................48, 59
R
reading limit .............................................40, 50
relaxation .......................................................50
ring method....................................................47
advantages............................................................103
correction.................................................................48
detection speed.......................................................52
filling level................................................................36
heavy density ..........................................................50
immersion depth......................................................53
immersion speed.....................................................53
interfacial tension ....................................................56
light density .............................................................50
main menu...............................................................47
measuring mode......................................................47
measuring speed.....................................................52
parameters in the setup ..........................................52
pull.....................................................................48, 56
push...................................................................48, 59
reading limit.............................................................50
relaxation ................................................................ 50
surface tension ....................................................... 54
ring tear-off measurement ............................ 51
ring-method
tear-off measurement ............................................. 51
rod method.................................................... 39
S
sample vessel
filling........................................................................ 36
setting up ................................................................ 36
saving............................................................ 37
select measuring method.............................. 27
sensitivity ...................................................... 70
set defaults.................................................... 75
setup ............................................................. 67
plate method........................................................... 41
ring method............................................................. 52
special characters ......................................... 29
Special functions........................................... 78
spirit level ...................................................... 13
standard output............................................. 77
Stirrer ............................................................ 30
stirrer speed .................................................. 72
surface tension
plate method........................................................... 43
ring method............................................................. 54
switching on and off ...................................... 20
T
taring ............................................................. 76
technical data.............................................. 109
temperatur sensor
internal, external, auto ............................................ 72
text fields....................................................... 74
time ............................................................... 74
transport........................................................ 12
W
warming-up time ........................................... 21
Z
Zuidema & Waters ........................................ 49