kruss K11 MK3 - Labdesk Output; Standard Output (3); Print Setup (4); Protection (5)

Special functions page 77
11.3 LabDesk output / Standard output (3)
This option is used for setting up data output for the printer or the data table in
LabDesk . If LabDesk
output is switched on then data transfer to LabDesk takes place
in CSV-format which can be processed by LabDesk.
*
You should only switch data output to standard output when you do not wish to
transfer the data to LabDesk, but only to a protocol printer. The protocol printer
cannot process the CSV-format.
The raw data (weight values) from the force sensor are only transferred when LabDesk
output
is switched on.
11.4 Print setup (4)
When the functions Print setup (4) is triggered the current settings are printed
respectively transferred to LabDesk.
Data capture must be switched on in LabDesk (Ö ch. 12.2.4).
11.5 Protection (5)
The force sensor is locked as long as no measurement is running. The force sensor
can be unlocked and re-locked with the function
Protection (5).
Avoid lateral force at the force sensor when unlocked because it can be damaged.