page 18 Setup and starting up
3.5.1 Assembling an external temperature measuring probe (optional)
1. Turn the thermostat jacket over. Attach the bracket for the temperature sensor to
the underside of the thermostat jacket with the help of the two screws supplied.
2. Fit the thermostat jacket as described in Chapter
10.3.3.
3. Lift the flap of the temperature sensor connector in the measuring chamber.
Connect the sensor plug to the sensor connector.
*
To read out the temperature of the external sensor when taking measurements:
Select the option
external
under
Temperature sensor
in the
Setup
menu.
3.5.2 Inert gas connector (optional)
An inert gas atmosphere can be applied to the measurement chamber.
Use only inert gases such as nitrogen or argon. Do not use gases which are
harmful, poisonous, inflammable or corrosive.
Connect the inert gas feed to the
GAS
connector on the back of the K11.
To Next Page
Loading...
Need help?
General
