Basic settings (setup menu and special functions) page 67
10 Basic settings (setup menu and special functions)
This section provides you with the necessary information for making the basic settings
in the setup menu. The settings made here normally only need to be altered on rare
occasions; however, you should still make sure that the currently set parameters are
suitable for the intended measurement. The setup menu consists of five pages; these
are described in the following subsections.
The setup menu is accessed with the key.
.
You can switch between the pages by using the two vertical arrow keys.
To make
alterations
to the settings press the key
.
The entries are confirmed with ENT. ESC exits the
Modify
mode.
*
The alterations are stored and retained.
To Next Page
Loading...
Need help?
General
