Kurzweil Artis SE - Restore

System Mode (Boot Loader)
Update Software
11-3
3. Follow the instructions specied on page 11-1 to enter System Mode. The Artis SE will
appear as a removable disk/drive on your computer.
4. Press the Param/Channel ▲ button once. e display shows .
5. Press the + button once. e display shows .
To select Update, press the + button once. e display shows
. Copy the le to the Artis SE removable disk/drive on
your computer. Once copied, “Safely Remove” or “Unmount” the removable disk/drive from
your computer.
6. Press the + button on the Artis SE. If the .KUF le is valid, the Artis SE will display the
message . is will take a minute or two.
7. Once you see a message press the Exit button to return to the System Mode
main menu.
Restore
Whenever you update the Artis SE’s software, a backup of the currently installed software is
made. is is in case of a need to revert back to the old software, such as if the new update
has problems or for troubleshooting.
NOTE: Only the previously installed version of the software is backed up. When you
perform a operation again, the current version is backed up. So, it’s possible to go
back and forth between versions.
Unlike the Update operation, the Restore operation can be performed without a computer
connected to the Artis SE:
1. Follow the instructions specied on page 11-1 to enter System Mode.
2. Press the Param/Channel ▲ button once. e display shows .
3. Press the + button once. e display shows .
4. Press the Param/Channel ▲ button again. is display shows .
5. Press the + button to restore the previous software version.
6. Press the Exit button to cancel and return to the System Mode main menu.