Kurzweil Artis SE - FX Select (Fxsel); Auto Power off; Auto Power off Time; Pedal Noise

Global Mode
The Global Parameters
9-4
FX Select (FXSel)
e FX Select (FXSel) parameter determines how the Artis SE responds to interrupts with
regards to eects. You can set this parameter to either Performance or Multitrack.
With FX Select set to Performance, the Artis SE minimizes disruption of existing eects
when changing Programs, and entry values will not disrupt sustained notes when changing
Programs in Program Mode.
When controlling the Artis SE from an external sequencer in Program Mode, setting FX
Select to Multitrack will minimize eect disruption.
Pressing Value Jump ( – & + buttons simultaneously) will set this parameter to
Performance.
Auto Power Off
e Auto Power O parameter turns the power saving feature on. When the Auto Power O
parameter is set to Enable, the Artis SE will automatically power o after the Auto Power
O Time has expired, from the last key press (physical or MIDI), button press, controller
movement, or USB MIDI activity.
Auto Power Off Time
If the Auto Power O parameter is set to Enable, then the Artis SE will power o after the
time selected by the Auto Power O Time parameter has elapsed.
e Artis SE will display warning messages, counting down before powering o.
Keyboard will power
off in 3 min
Press a key or move any Artis SE control to dismiss the warning message. After dismissing
this message, the Artis SE will wait the selected amount of time before showing this warning
again.
Pedal Noise
Some piano Programs have a Pedal Noise feature programmed into the sound. is
parameter allows you to turn the Pedal Noise o if you prefer not to use it. If it is on, it will
only activate noise on those Programs that have been programmed to use it.