Multi Mode
Selecting Multis
7-2
Muting Zones
Pressing a Zone On/O button will mute or unmute the Zone. An active/unmuted Zone
button has a lit LED. e LED of an inactive/muted Zone button is not lit.
Selecting Multis
When you are in Multi Mode, there a few ways to select Multis.
• To select any Multi in the current Category, press a Program/Multi button.
• To select a Multi in a dierent Category, press the Category Button of choice and
then the Program/Multi Button to select from the 8 Multis in the Category.
• To select the Category Default Multi, simply press a Category Button.
• To switch between the Factory and User Multis, press the User Button, followed by
a Category button and then a Program/Multi button. Unlike factory Multis which
have 8 Multis per category, User Multis have 16 Multis per category. Two sets of 8
User Multis can be selected for each Category by pressing the Bank button.
• e Alpha Wheel and the + & – buttons allow you to advance through the Multis
one at a time. When you reach the end of the Category, advancing further will go to
the next Category.
• If a Multi is assigned to a Favorite Button, pressing that button will go directly to the
assigned Multi.
The Display
In Multi Mode, the top line of the display shows the current Mode and MIDI transposition.
e lower line shows the Multi ID number and name.
Pop Up Messages
Actions such as moving a controller cause the display to show pop up messages. After a short
time the display returns to show the current Multi.
To Next Page
Loading...
