Kurzweil Artis SE - Controlling Program Parameter Assignments from Multi Mode; Entry Value; Exit Value; The Pedal Switch & Switch Button Parameters

Multi Edit Mode
The Zone-specic Parameters
8-13
Controller
Number
Controller
Destination
Description
137 ProgDec Program Decrement—decrements current Program number.
138 ProgGoto Go to Program—selects Program.
139 SetupInc Multi Increment—increments current Multi number.
140 SetupDec Multi Decrement—increments current Multi number.
141 SetupGoto Go to Multi—selects Multi.
142 Start
143 Stop
144 Continue
145 TransUp Transpose Up (ST)
146 TransDown Transpose Down (ST)
Controlling Program Parameter Assignments from Multi Mode
Commonly you will want to assign a physical controller in a Multi to control the same
Program parameter that it controlled in Program Mode. In the Dest parameter list,
destinations that are assigned to parameters for the Program of the current Zone will show
the Program Parameter name instead of that Controller Destination’s default name. Select
one of these destinations to control an assigned Program parameter.
Entry Value
e Entry Value parameter determines the value of the continuous controller that is sent as a
MIDI message when the current Multi is loaded. You can set this parameter to any number
between 0 and 127, or to None.
If Entry Value is set to None, when you load the current Multi the controller will be at
whatever value it last had in that MIDI channel.
Exit Value
e Exit Value parameter determines the value of the continuous controller that is sent as a
MIDI message when the current Multi is exited. You can set this parameter to any number
between 0 and 127, or to None.
If Exit Value is set to None, then when you leave the current Multi the controller will be at
whatever value it last had in that MIDI channel.
The Pedal Switch & Switch Button Parameters
• PdSw1a
• PdSw1b
• PdSw2a
• PdSw2b
• SW1 Button