Storage Mode
10-3
Load (Overwrite)?
e Load (Overwrite)? option allows you to load a le containing previously saved
User Programs and User Multis from a device connected to the Artis SE via USB. Selecting
Load (Overwrite)? loads the previously saved User Programs and User Multis
and deletes (overwrites) the existing User Programs and Multis currently in the Artis SE. If
there are fewer objects in the le than are currently stored in User locations, the additional
locations will be emptied.
Press the + button to begin the process of loading from the selected device (USB or PC).
If the device is not attached or not recognized, the display will prompt you to connect the
selected device or unplug and reconnect it. Follow the instructions on the display. If PC
was selected for the Device option, then the Artis SE will appear as a removable disk/drive
on your computer. Copy the le, containing your previously saved User Programs and User
Multis, from your computer into the Artis SE removable disk/drive. If USB was selected for
the Device option, use the Param/Channel ▲ or ▼ buttons to select the le to load from the
list of les on the Artis SE display.
Copy file to drive
After Press [Assign]
Press Assign, and a warning message will appear before executing the Overwrite:
Overwrite can delete
Are you sure?[Assign
Pressing Assign again will load the le; pressing Exit (or the – button) will cancel the
process without overwriting the current les, and return to the Load (Overwrite)?
option.
When loading new les the display shows File Loading..., and when complete
File loaded.
If no le is in the Artis SE temporary drive during the load or an error occurs during the
load operation, then the display will show the error message, Load Error and a message
specifying the reason for the error.
To Next Page
Loading...
