Kurzweil Artis SE - Mode; Destination (Dest); On Value (Onval); Off Value (Offval)

Multi Edit Mode
The Zone-specic Parameters
8-14
• SW2 Button
e following are parameters that aect the behavior of the Pedal Switch and Sw button
controllers.
Mode
e Mode parameter determines the switching action of the switch controllers. You can set
this parameter either of three settings:
Momentary
A momentary switch is one that is only in the “on” state when it is
pressed. As soon as you release the switch, it goes into the “o” state.
Toggled
A toggled switch is one that maintains its state after it is pressed. So, if
the switch is currently in the “o” state, pressing it once will put it in the
“on” state. Pressing it again will put it back in the “o” state.
Destination (Dest)
e Destination parameter determines the Controller Destination for the currently selected
controller in the currently selected Zone. For a list of the Multi Destination Controllers and
their descriptions, see Destination (Dest) on page 8-11.
On Value (OnVal)
e On Value is the MIDI value sent when the switch is set to On. You can set this
parameter to any number between 0 and 127, or to None.
Off Value (OffVal)
e O Value is the MIDI value sent when the switch is set to O. You can set this
parameter to any number between 0 and 127, or to None.
Entry State
e Entry State parameter determines the state of the switch controller that is sent as a MIDI
message when the current Multi is loaded. You can set this parameter to None, On, or O.
If Entry State is set to None, when you load the current Multi the controller will be at
whatever value it last had in that MIDI channel.
Exit State
e Exit State parameter determines the state of the Pedal Switch that is sent as a MIDI
message when the current Multi is exited. You can set this parameter to None, On, or O.
If Exit State is set to None, then when you leave the current Multi the controller will be at
whatever value it last had in that MIDI channel.