Kurzweil Artis SE - Program Demo; The Display; Pop up Messages

Program Mode
Selecting Programs
6-2
• Choosing a Program in the user Categories, while in the factory Categories, or
choosing a Program in a factory Category while in a user Category, requires pressing
the User button, followed by a Category button and then a Program/Multi button.
• e Alpha Wheel and the – and + buttons allow you to advance through the
Programs one at a time. When you reach the end of the Category, advancing further
will go the the next Category.
• If a Program is assigned to a Favorite button, pressing that button will go directly to
the assigned Program.
Program Demo
If you want to quickly hear what a Program sounds like in performance, try the Program
Demo Function
In Program Mode only, pressing the 3 & 4 Program/Multi buttons performs the Program
Demo Function. e Program Demo Function plays a Demo Song for the currently selected
Program.
Press the Exit button to exit Program Demo.
If you try to use the Program Demo Function from any other Mode, the display will give you
a message indicating you are not in Program Mode.
The Display
In Program Mode, initially the top line of the display shows the current Mode, Transposition
(XPOSE) and MIDI channel.e Program ID number and name are displayed on the
second line. If a slider is moved, the second line displays the parameter aected and the value
change.
PROG Xpose:0 Ch:1
1 Concert Piano
Pop Up Messages
Some actions, such as moving a slider, cause the display to show pop up messages on the
second line indicating the controller assignment. After a short time the display returns to
show the current Program.