Kurzweil Artis SE - Store

Storage Mode
10-2
NOTE: Selecting PC for the Device option will disconnect any MIDI device connected via
USB. If the Artis SE is currently connected to your computer via USB as a MIDI device,
you may want to close any MIDI applications connected to the Artis SE in order to avoid
problems when MIDI is disconnected.
Store?
e Store? option allows you to save every User Program and User Multi to a device
connected to the unit via USB. After selecting a device with the Device option, connect a
USB cable or USB device to a USB port on the Artis SE’s rear panel.
With the Store? option selected, press the + button and the display will show the
message “Save le to [device]?”. Press the + button again to start the process of saving the
les to the selected device (USB or PC). If the device is not attached or not recognized, the
display will prompt you to connect the selected device or unplug and reconnect it. Follow
the instructions on the display.
When the device has been recognized, the display shows the default le name for all objects
(ALLOBJTS). You can edit this before saving, using the + button to move the cursor, and
the Alpha Wheel to select alphanumeric characters.
Save file with NAME
ALLOBJTS
Press the Save button or the Assign button to store your user objects to the selected
device (or press Exit to cancel). e display will show the “Saving… ” message then a
conrmation. If you are storing to a PC, you must copy the saved le from the Artis SE
virtual drive to your computer before continuing.
Save Successful
Press [Assign] Key
If an error occurs during the save operation, then the display will show the error message,
Save Error.