Kurzweil Artis SE - Continuous Controller Parameters; Destination (Dest)

Multi Edit Mode
The Zone-specic Parameters
8-11
Continuous Controller Parameters
• Mod Wheel
• Sliders 1 through 8
• CC Pedal
Destination (Dest)
Use the Destination parameter to assign the Artis SE physical controllers (Sliders, Pedals,
Switches, Mod Wheel, etc.) to control Program parameters or send MIDI continuous
controller messages (CCs) to external MIDI gear.
e Destination parameter determines the MIDI CC controller number that a physical
controller will send to the Program in the currently selected Zone. By default, these CC
messages are also sent to the MIDI Out and USB ports on the Channel of that Zone
e list of CC controller numbers below shows the default assignments for each destination.
Programs respond to some of these CCs to do standard MIDI functions like volume and
panning. Other external MIDI gear (sound modules, computer software) may respond to
standard MIDI CC messages as well.
Controller
Number
Controller
Destination
Description
0 Bank MIDI Bank change message.
1 MWheel Default destination for Mod Wheel
2 Breath Default assignment for breath controller in compatible synths
3 MIDI 03 MIDI Controller 3
4 Foot Default assignment for continuous foot controller in compatible synths
5 PortTim Monophonic Artis SE Programs respond to this Controller if portamento is
turned on.
6 Data MIDI Controller 6.
7 Volume MIDI Volume
8 Balance MIDI Balance
9 MIDI 09 MIDI Controller 9
10 Pan MIDI Pan
11 Express Default assignment for CC Pedal. In most Programs it acts as a volume
control. It scales between 0 and the current value of Volume.
12 MIDI 12 Default assignment for Slider 5 (Filter-A Slider in Program Mode)
13 MIDI 13 Default assignment for Slider 6 (Filter-B Slider in Program Mode)
14-15 MIDI 14-15 MIDI Controllers 14-15
16-19 Ctl A - D MIDI Controllers 16-19
20-26 MIDI 20-26 MIDI Controllers 20-26
27 MIDI 27 Default assignment for Slider 7 (FX-A Slider in Program Mode. Sometimes
controls delay amount or another effect in Artis SE programs.)
28 MIDI 28 Default assignment for Slider 8 (FX-B Slider in Program Mode. Usually
controls reverb amount in Artis SE programs.)
26 MIDI 29 Default assignment for SW 1 in Program Mode. Usually enables a pad
layer or an effect in Program Mode.
30–31 MIDI 30–31 MIDI Controllers 30–31