Kurzweil Artis SE - Assign; Assign + Zone (1-4) Button; Assign + Controller; Assign + Key

Multi Edit Mode
The Zone-specic Parameters
8-5
Assign
In Multi Edit Mode, pressing and holding the Assign button while pressing a switch, key, or
moving a controller performs Assign in the following cases:
Assign + Zone (1–4) Button
Pressing and holding the Assign button while pressing one of the four Zone buttons will
select that Zone for editing. e currently selected parameter will be shown for the selected
Zone. If the current parameter is a Multi common parameter and not a Zone parameter,
Assign + Zone button will not do anything.
Assign + controller
Pressing and holding the Assign button while moving a controller (a slider, SW button, Mod
Wheel or any pedal) jumps to selecting the rst parameter of that controller in the current
Zone. is allows you to quickly assign a controller to a destination.
To edit the currently selected parameter, simply use the – & + buttons below the Alpha
Wheel. Pressing Value Jump (both – & + buttons simultaneously) will jump to a dierent
value depending on the parameter.
Assign + key
With the LoKey or HiKey parameter selected, hold the Assign button and strike a key on the
keyboard to set the LoKey or HiKey.
The Zone-specic Parameters
Each of the four Zones in Multi has multiple parameters that determine its behavior. Since
the Zones of a Multi are independent of each other, changing a parameter for a certain Zone
will not aect the parameters of any other Zone.
Local Program (Local Prog)
e Local Program parameter determines the Program to be loaded for the currently selected
Zone. You can set this parameter to any Artis SE Program (0 – 512). e display shows the
Program number and name (usually scrolling text).
Editing this parameter also changes the MIDI Bank and MIDI Program parameters,
described below.