Multi Mode
Saving User Multis
7-9
Naming a User Multi
To rename the new Multi press a Param/Channel button until you see “Rename Multi as:”.
e current Multi name will appear with a cursor line under the rst letter. Use the Alpha
Wheel to select characters for the new Program name. Press the + or – button to move the
cursor to another character.
Rename Multi as: 2/2
Samba Layers
_
Multi names can total 16 characters in length. Choosing a Space character, or pressing
Program/Multi button 6 will change the current character to a space. Pressing Program/
Multi button 7 will insert a space, moving the selected character to the right and deleting
the rightmost character if needed. Pressing Program/Multi button 8 will delete the selected
character, moving all characters to the left.
Completing a User Multi Save
Press the Save button to complete the saving process, or press the Exit button to exit without
saving.
If you press a Mode button to switch Modes before you save the Multi, the display will show
a message. Press Save to continue in Save mode, or Assign to save the Multi with the current
settings, or Exit to cancel without saving.
Do you want save it?
[Assign]Save[Exit]No
After successfully saving, the Multi will be selected in Multi Mode in the User Bank. To nd
the Multi again later, make sure to press the User bank button while in Multi Mode.
To Next Page
Loading...
