Kurzweil Artis SE - Page 105

Troubleshooting
Common Problems
12-3
e audio cables are not securely
plugged into the Artis SE, audio
system, or mixer.
Set the volume of the audio or mixer to the
lowest level, securely plug in the audio cables
on both ends, and then slowly turn up the
volume.
e Sound parameter stops MIDI
Data
Use the Sound button switch to Local +
MIDI.
e audio cable is of an incorrect type. Obtain and securely connect an audio cable
of the correct type. e Artis SE accepts both
balanced (TRS) and unbalanced (TS) 1/4-
inch audio cables.
If you can hear sound but it is low or distorted, check if one of the following might be the
issue:
e audio cables are not securely
plugged into the Artis SE, audio
system, or mixer.
Set the volume of the audio system or mixer
to the lowest level, securely plug in the audio
cables on both ends, and then slowly turn up
the volume.
A received MIDI volume message has
specied a low volume.
Set the volume of the audio system or mixer
to the lowest level. Disconnect all MIDI
cables, press the Sound button to select Local
or MIDI+Local, and reset the volume level
on the Artis SE, by pressing Panic (see page
3-14). Finally, slowly turn up the volume
level of the audio system or mixer.
e current Multi has another
controller assigned to volume, and it is
turned down.
Select a dierent Multi. Or change the
problematic controller setting by editing the
Multi in Multi Edit Mode.
e input to the audio system is set
for low impedance instead of high
impedance.
Set the volume of the audio or mixer to the
lowest level, change the impedance setting,
and then slowly turn up the volume of the
audio system or mixer.
e input trim to the audio system or
mixer is set too low.
Slowly turn up the trim.