Kurzweil PC3LE - Page 283

Keymap and Sample Editing
Editing Samples
12-11
Loop Switch
Thisparameteractivatesordeactivatestheloopingofthecurrentlyselectedsample.Whensetto
On,thesamplewillloopaccordingtothesettingsontheTRIMpage.WhensettoOff,the
samplewillplaythroughtoitsEndpointandstop.
Playback Mode (Playback)
Thisparameterletsyoumodify the
directioninwhichthesampleisplayed.Setittoavalueof
ReverseifyouwantthesampletoplayfromitsEnd(E)pointtoitsStart(S)point.Choosea
valueofBidirectionaltocausethesampletoplayfromStarttoEnd,thenreversedirectionand
play
againfromEndtoLoopandback,repeatinguntilthenotetriggerisreleased(thisworks
onlywhentheLoopSwitchparameterissettoOn).
Alternative Sample Sense (AltSense)
Thisprovidesaconvenientwaytoactivatethealternativestartofasample.WhensettoNormal,
thealternativestartwillbeused
whentheAltSwitchcontrolisOn(thisissetontheKEYMAP
page),orwhenthecontrolsourceassignedtoitisaboveitsmidpoint.WhensettoReverse,the
alternativestartwillbeusedwhentheAltSwitchcontrolisOff,orwhenthecontrolsource
assignedto
itisbelowitsmidpoint.
Ignore Release (IgnRelease)
WhensettoavalueofOff,thesamplewillreleasenormallywhenthenotetriggerisreleased.
WhensettoOn,thenotewillnotrelease,evenwhenthenotetriggerisreleased.Thissetting
shouldbeusedonlywithsamplesthatnormally
decaytosilence;nondecayingsampleswill
playforeveratthissetting.Thisparameterisequivalenttothe IgnReleaseparameteronthe
LAYERpage,butaffectsonlythecurrentlyselectedsample.
SampleRate and NumSamples
Theseparameterscannotbeedited,butshowthesample’ssamplerateandthesample’slength
insamples.Samplesthatarelonger
than1millionsamplesaredisplayeda1Ms.
The Soft Buttons on the MISC Page
Rename
Callupthepagethatenablesyoutochangethenameofthecurrentsample.
Save
Starttheprocessofsavingthecurrentsample.
Delete
Starttheprocessofdeletingthecurrentsample.Ifthecurrentsamplehasbeensavedtoauser
ID#(above1024,)thisdeletesthesamplesettingsatthatID#(thesampleaudiodatacannotbe
deletedandremainsinthefactoryROMunderthesample’soriginalfactoryID#.)Ifthecurrent

samplehasbeensavedtoafactoryROMID#(1‐1024,)thisrestoresthefactorydefaultsettings
andaudiodataforthatsampleID#.