This document contains proprietary information of KVH Industries, Inc. and neither this document nor said proprietary information shall be
published, reproduced, copied, disclosed, or used for any purpose without the express written permission of a duly authorized KVH representative.
Page 45 of 77
8.21 =linfmt
8.21.1 Description
This command sets the linear (accelerometer) data format used for output in Normal Mode. It
can be set to either acceleration in g’s (default) or delta velocity. If setting to delta velocity, be
sure to set the units using the =LINUNITS command.
8.21.2 Usage
=LINFMT,<ACCEL|DELTA|RESET>
8.21.3 Response
LINFMT,<ACCEL|DELTA|RESET>
8.22 ?linfmt
8.22.1 Description
This command query returns the linear (accelerometer) data output format used in Normal
Mode, either acceleration in g’s or delta velocity.
8.22.2 Usage
?LINFMT
8.22.3 Response
LINFMT,<ACCEL|DELTA>
8.23 =linunits
8.23.1 Description
This command sets the linear (accelerometer) data output units. Only applies if the linear data
output format is not set to acceleration in g’s, which is the default selection. See the =LINFMT
command for details on changing the linear data output format.
As an example, if the format is set to delta velocity and you select the output units to be meters
(default), the data you receive will be measured in delta meters per second. If you change the
units to feet, you will receive data in delta feet per second.
8.23.2 Usage
=LINUNITS,<METERS|FEET|RESET>
8.23.3 Response
LINUNITS,<METERS|FEET|RESET>
To Next Page
Loading...
Need help?
General