This document contains proprietary information of KVH Industries, Inc. and neither this document nor said proprietary information shall be
published, reproduced, copied, disclosed, or used for any purpose without the express written permission of a duly authorized KVH
representative.
8.24 ?linunits
8.24.1 Description
This command query returns the linear (accelerometer) data output units. This setting only has
meaning if the linear data output format is changed from the default value of acceleration in
g’s. See the =LINFMT command for details.
8.24.2 Usage
?LINUNITS
8.24.3 Response
LINUNITS,<METERS|FEET>
8.25 ?logs
8.25.1 Description
This is a diagnostic command that gets the BIT status logs stored in flash. A user might be
requested to do this as part of service support. (See Table 5-12 through Table 5-19 for details
on logged bit statuses.)
8.25.2 Usage
?LOGS
8.25.3 Response
Start of log entries!
Log 1:
Source - Start up
Format - BIT Status
Data - 0x7F7F7F7F7F7F7F7F
Log 2:
Source - ?BIT
Format - BIT Status
Data - 0x7F7F7F7F7F7F7F7F
End of log entries!
To Next Page
Loading...
Need help?
General