System Menu > NetworkSettings
482
[Custom Setup]
Item Description
[Network Name (SSID)] Set the SSID (Service Set Identifier) of the wireless LAN to which the
machine connects.
NOTE
Up to 32 characters can be entered.
[Connection Mode] Set Connection Mode.
Value: [Ad Hoc], [Infrastructure]
NOTE
[Ad Hoc]
Directly communicates with the device without going through an
access point. This method cannot be used to connect to two or more
devices.
[Infrastructure]
Performs communication through an access point.
[Channel] Performs channel configuration. Use [-][+] or the numeric keys to set the
value.
Value: 1 to 11
[Network Authentication] Select network authentication type. To select other options, open the
device home page from a computer.
Value: [Open], [Shared], [WPA-PSK]
*1
, [WPA2-PSK]
*1
*1 Not displayed when [Ad Hoc] is specified in [Connection Mode].
[Encryption] Select encryption method. If you selected a setting other than
[Disabled], enter the WEP key or preshared key. The setting values vary
depending on the Network Authentication setting. Select [Data
Encryption].
• If the network authentication type is [Open] or [Shared]
Value: [Disabled], [WEP]
• If the network authentication type is [WPA-PSK] or [WPA2-PSK]
Value: [TKIP]
*2
, [AES], [Auto]
*2
, [Preshared Key]
*2 Not displayed when [WPA2-PSK] is specified in [Network
Authentication].
NOTE
• If you selected [WEP], enter the WEP key. Up to 26 characters can be
entered.
• If you selected [TKIP], [AES], or [Auto], enter the pre-shared key. 8 to
64 characters can be entered.
To Next Page
Loading...
