Kyocera FS-3040MFP

2LW/2LX
1-5-41
18. Remove one connector.
19. Remove seven screws and then
remove the power source PWB.
20. Check or replace the power source
PWB and refit all the removed parts.
Note:
While assembling the rack component,
align the guiding holes on either the
upper cover rack and the front cover
rack with each other.
Figure 1-5-62
Figure 1-5-63
Screw
Screws
Heat sink plate
Screws
Screw
Screw
Power source
PWB
Connector
Power source
PWB plate
Guiding holes
Guiding holes
Upper cover rack
Front cover
rack
Rack cover