Kyocera FS-3040MFP

2LW/2LX-6
1-3-2
(2) Maintenance modes item list
Section
Item
No.
Content of maintenance item
Initial
setting
General U000 Outputting an own-status report -
U001 Exit Maintenance Mode -
U002 Setting the factory default data -
U019 Firmware Version -
Drive,
paper
feed and
paper
conveying
system
U034 Adjust Paper Timing Data
LSU Out Top
LSU Out Left
221/0/0/0
305/22/0/0/0/0/0
Optical
U065 Adjust Scanner Motor Speed
0/0
U066 Adjust Table Leading Edge Timing
0/0
U067 Adjust Table Center
0/0
U068 Adjust DP Scan Position
0/0
U070 Adjust DP Motor Speed
0
U071 Adjust DP Leading Edge Timing
0/0/0/0/0
U072 Adjust DP Original Center
0/0/0
Operation
panel and
support
equipment
U203 Checking DP operation -
U222 Setting the IC card type Other
Mode setting U250 Setting the maintenance cycle 300000
U251 Checking/clearing the maintenance count -
U252 Setting the destination -
U253 Switching between double and single counts Double count
U260 Selecting the timing for copy counting EJECT
U285 Setting service status page ON
U332 Setting the size conversion factor 1.0
U345 Setting the value for maintenance due indication 0
Image
processing
U402 Adjust Print Margin
30/25/25/50
U403 Adjust Scanning Margin(Table)
2.0/2.0/2.0/2.0
U404 Adjust Scanning Margin(DP)
3.0/2.5/3.0/4.0
U411 Adjusting the scanner automatically -
U425 Setting the target -
Fax U600 Initializing all data -
U601 Initializing permanent data -
U603 Setting user data 1 DTMF
U604 Setting user data 2 2 (120 V)
1 (220-240 V)