7: Networking
EMG™ Edge Management Gateway User Guide 119
Figure 7-12 Network > VPN (2 of 2)
2. Enter the following:
Enable VPN Tunnel Select to create a tunnel. Disabling this option will terminate any currently
running tunnel.
Note: The VPN peer that sends the first packet in tunnel bringup is the
initiator or client; the VPN peer that listens for and responds to the first
packet is the responder or server. In general, the responder / server side
should be started before the initiator / client side. If it is desired to have the
console manager VPN tunnel automatically reconnect when the remote
peer disconnects and then reconnects, the console manager side of the
tunnel should be started first so that it will act as a responder or server. If
the console manager side of the tunnel is started after the remote peer, the
console manager will act as a initiator / client, and may not automatically
reconnect when the remote peer disconnects and is brought back up.
Name The name assigned to the tunnel. Required to create a tunnel.
Remote Peer The IP address or FQDN of the remote host's public network interface. The
special value of any can be entered to signify an address to be filled in by
automatic keying during negotiation. The console manager will act as a
responder/server.
Remote Id How the remote host should be identified for authentication. The Id is used
to select the proper credentials for communicating with the remote host.
To Next Page
Loading...
Need help?
General
