7: Networking
EMG™ Edge Management Gateway User Guide 91
Fail-Over Cellular Gateway Firmware
Note: The HSPA+ or Sierra fail-over device must be selected in order for you to be able
to update the firmware.
Load Cellular Gateway Firmware Options
3. To save your entries, click the Apply button. Apply makes the changes immediately and
saves them so they will persist when the EMG is rebooted.
Update Firmware
(check box)
Select this option to update firmware on the HSPA+ gateway or the Sierra gateway.
The Functional Firmware file and the Radio Firmware file (required for the Sierra
gateway only) will be transferred to the EMG using the method selected by the
Load Firmware via option. Once the file(s) have been transferred to the EMG, the
EMG will initiate the firmware update on the gateway.
Functional Firmware
Filename
Enter the name of the firmware filename exactly as it is represented.
Radio Firmware
Filename
Enter the name of the radio firmware filename exactly as it is represented.
Load Firmware via Select the method to load the firmware from the options in the drop-down menu.
Options are: FTP, SFTP, SCP, USB, SD Card, and HTTPS. FTP is the default.
If you select HTTPS, the Upload File link becomes active. Select the link to open
a popup window that allows you to browse to a firmware update file to upload.
If you select NFS, the mount directory must be specified.
Note: Connections available depend on the model of the EMG unit.
USB Port The USB Port selection becomes active when you choose to Load Firmware via
USB. EMG provides one USB port called U1 in the interface. The firmware files
must be stored in the top level directory of the USB flash drive.
FTP/SFTP/SCP
Server
Enter the IP address or host name of the server used for obtaining the firmware
files. May have up to 64 alphanumeric characters; may include hyphens and
underscore characters.
Path Enter the path on the server for obtaining firmware update files.
Login Enter the user login for the FTP/SFTP/SCP server to verify access. May be blank.
Password/
Retype Password
Enter the FTP/SFTP/SCP user password. Retype the password in the Retype
Password field.
To Next Page
Loading...
Need help?
General
