10: Device Ports
EMG™ Edge Management Gateway User Guide 223
4. You have the following options:
- To add a host to the host list, click the right arrow. The host displays in the Hosts box.
- To remove a host from the host list, select the host in the Hosts box and click the
left arrow.
- To give the host a higher precedence, select the host in the Hosts box and click the
up arrow.
- To give the host a lower precedence, select the host in the Hosts box and click the
down arrow.
5. Click the Edit Host List button. After the process completes, a confirmation message is
displayed on the page.
To delete a host list:
1. Select the host list in the Host Lists table.
2. Click the Delete Host List button. After the process completes, a confirmation message is
displayed on the page.
Host List Commands
Go to Host List Commands to view CLI commands which correspond to the web page entries
described above.
Escape Sequence The escape character used to get the attention of the SSH or Telnet client. It is
optional, and if not specified, Telnet and SSH use their default escape character.
For Telnet, the escape character is either a single character or a two-character
sequence consisting of '^' followed by one character. If the second character is '?',
the DEL character is selected. Otherwise, the second character is converted to a
control character and used as the escape character.
For SSH, the escape character is a single character.
To Next Page
Loading...
Need help?
General
