17: Command Reference
EMG™ Edge Management Gateway User Guide 411
Parameters
name <DIO Port Name>
wakeup <on|off>
state <on|off>
normalstate <on|off>
latch <enable|disable>
Description
Configure the DIO relay/output port on the front of the EMG:
show dio
Diagnostic Commands
diag arp
Syntax
diag arp|arp6 [email <Email Address>]
Description
Displays the Address Resolution Protocol table (for IPv4) or the Neighbor table (for IPv6) for
mapping IP Addresses to hardware addresses.
diag internals
Syntax
diag internals [email <Email Address>]
Enable debug printing on the next EMG reboot:
diag internals [printapplication <enable|disable>
printconnection <enable|disable>
printmanagement <enable|disable>
Description
Displays information on the internal memory, storage and processes of the EMG. You can
optionally email the displayed information.
diag iperf
Syntax
diag iperf mode <server|client> [host <iPerf Server IP Address or Name>]
[options <iPerf options>] [email <Email Address>]
To Next Page
Loading...
Need help?
General
