9: USB/SD Card Port
EMG™ Edge Management Gateway User Guide 178
Figure 9-1 Devices > USB / SD Card
To configure a USB/SD card storage port:
1. Insert any of the supported storage devices into the USB port or the SD card slot on the front
of the EMG unit.
2. Click the USB/SD Card tab. Figure 9-1 shows the page that displays.
3. Click the radio button (on the far right) of a USB or SD card device storage port.
4. Click Configure.
- Figure 9-2 shows the page that displays if a USB storage device is inserted.
- Figure 9-3 shows the page that displays if an SD Card is inserted.
To Next Page
Loading...
Need help?
General
