10: Device Ports
EMG™ Edge Management Gateway User Guide 198
This menu allows the administrator to query status and control any of the power supplies that
provide power to the device connected to the device port and change the Baud Rate of the device
port.
Note: The Baud Rate can be configured while connected to a device port by entering the
Power Management Sequence. This will display the Power Management and Baud
Rate menu, which provides an option to set the Baud Rate.
To configure power management settings for a device port:
1. Connect to a specific port on the Devices > Device Ports page according to instructions in To
open the Device Ports - Settings page: (on page 187).
2. Click the Settings link beside Power Management to access the Device Ports - Power
Management page.
To Next Page
Loading...
Need help?
General
