Lantronix EMG 8500 - Page 273

12: Scripts
EMG™ Edge Management Gateway User Guide 273
while True:
output_str = proc.stdout.readline()
if b'RADIUS settings successfully updated' in output_str:
break
elif b'set radius' not in output_str:
# RADIUS command returned an error
s1 = str(output_str)
s2 = s1.split("\\r")[1]
print("RADIUS command returned: " + s2.split("\\n")[0])
proc.stdin.close()
proc.terminate()
proc.wait()
sys.exit(1)
proc.stdin.write(b'set radius state enable\n')
proc.stdin.flush()
while True:
output_str = proc.stdout.readline()
if b'RADIUS settings successfully updated' in output_str:
break
elif b'set radius' not in output_str:
# RADIUS command returned an error
s1 = str(output_str)
s2 = s1.split("\\r")[1]
print("RADIUS command returned: " + s2.split("\\n")[0])
proc.stdin.close()
proc.terminate()
proc.wait()
sys.exit(1)
print("RADIUS settings updated and enabled.")
proc.stdin.close()
proc.terminate()
proc.wait()
sys.exit(0)