8: Device Ports
SLC™ Console Manager User Guide 134
CHAP Secret The CHAP secret associated with this site. If a modem has sites enabled and
CHAP authentication enabled, then at dial-in, if the remote server sends a name
in the CHAP challenge response that matches the CHAP host of a site, the CHAP
secret for the site will be used to authenticate the CHAP challenge response sent
by the remote server.
Authentication The type of authentication, PAP or CHAP, for which this site is applicable. On
dial-in authentication, only sites with the authentication type that matches the
authentication type configured for the modem will be used to try to find a matching
site.
Timeout Logins For text dial-in connections, the connection can time out after the connection is
inactive for a specified number of minutes.
Negotiate IP Address If the SLC console manager and the remote server should negotiate the IP
addresses for each side of the PPP connection, select Yes. Select No if the
address of the SLC unit (Local IP) and remote server (Remote IP) need to be
specified.
Static Route IP
Address
The Static Route IP Address, Subnet Mask and Gateway must be configured for
dial-on-demand sites. The SLC device will automatically dial-out and establish a
PPP connection when IP traffic destined for the network specified by the static
route needs to be sent.
Note: Static Routing must be enabled on the Network - Routing page for dial-on-
demand connections.
Static Route Subnet
Mask
The subnet mask for a dial-on-demand connection.
Static Route Gateway The gateway for a dial-on-demand connection.
Dial-out Number The dial-out number must be specified for dial-on-demand sites. This indicates
the phone number to dial when the SLC console manager needs to send IP
traffice for a dial-on-demand connection.
Dial-out Login User ID for authentication when dialing out to a remote system. May have up to
32 characters. This ID is used for authenticating the SLC unit during the dial-out
portion of a dial-back (including CBCP server) and dial-on-demand.
Dial-out Password Enter the password for authentication when dialing out to a remote system. May
have up to 64 characters. This password is used for authenticating the SLC
device during the dial-out portion of a dial-back (including CBCP server) and dial-
on-demand.
Retype Password Re-enter the password for authentication when dialing out to a remote system.
May have up to 64 characters. This password is used for authenticating the SLC
console manager during the dial-out portion of a dial-back (including CBCP
server) and dial-on-demand.
Dial-back Number The phone number to dial on callback for text or PPP dial-back connections. A
site must successfully authenticate, have Allow Dial-back enabled and have a
Dial-back Number defined in order for the site to be used for callback.
Allow Dial-back If enabled, the site is allowed to be used for dial-back connections.
Dial-back Delay For dial-back and CBCP Server, the number of seconds between the dial-in and
dial-out portions of the dialing sequence.
Dial-back Retries For dial-back and CBCP Server, the number of times the SLC unit will retry the
dial-out portion of the dialing sequence if the first attempt to dial-out fails.
Modem Timeout Timeout for dial-in and dial-on-demand PPP connections. Select Yes (default) for
the SLC device to terminate the connection if no traffic is received during the
configured idle time. Enter a value of from 1 to 9999 seconds. The default is 30
seconds.
To Next Page
Loading...
Need help?
General