6: Basic Parameters
SLC™ Console Manager User Guide 62
Updating an IP Filter
To update an IP filter rule set:
1. From the Network > IP Filter page, the administrator selects the IP filter ruleset to be edited
and clicks the Edit Ruleset button to return to the Network > IP Filter Ruleset (Adding/Editing
Rulesets) page (see Figure 6-3).
2. Edit the information as desired and click the Apply button.
Deleting an IP Filter
To delete an IP filter rule set:
1. On the Network > IP Filter page, the administrator selects the IP filter ruleset to be deleted and
clicks the Delete Ruleset button.
Mapping a Ruleset
The administrator can assign an IP Filter Ruleset to a network interface (Ethernet interface) a
modem connected to a Device Port.
To map a rule set to a network interface:
1. On the Network > IP Filter page, select the IP filter ruleset to be mapped.
2. From the Interface drop-down list, select the interface and click the Map Ruleset button. The
Interface and rule set display in the IP Filter Mappings table.
To delete a mapping:
1) On the Network > IP Filter page, select the mapping from the list and click the Delete
Mapping button. The mapping no longer displays.
2) Click the Apply button.
IP Filter Commands
The following CLI commands correspond to the web page entries described above.
To enable or disable IP filtering for incoming network traffic:
set ipfilter state
To set IP filter mapping:
set ipfilter mapping <parameters>
Parameters:
ethernet <1|2> state <disable>
ethernet <1|2> state <enable> ruleset <Ruleset Name>
deviceport <1..48> state <disable>
deviceport <1..48> state <enable> ruleset <Ruleset Name>
To Next Page
Loading...
Need help?
General