Lantronix SLC8 User Manual

5: Web and Command Line Interfaces
SLC™ Console Manager User Guide 47
Logging Out
To log off the SLC web interface:
1. Click the Logout button located on the upper left part of any user interface page. You are
brought back to the login screen when logout is complete.
Web Page Help
To view detailed information about an SLC web page:
1. Click the Help button to the right of any user interface page. Online Help contents will appear
in a new browser.
Command Line Interface
A command line interface (CLI) is available for entering all the commands you can use with the
SLC console manager. You can access the command line interface using Telnet, SSH, or a serial
terminal connection. Each command that corresponds to the web interface description in each
chapter gets listed as a cross-reference to the complete command syntax and description
contained in Chapter 15: Command Reference.
Note: By default, Telnet is disabled and SSH is enabled. To enable Telnet, use the
Services > SSH/Telnet/Logging web page, a serial terminal connection, or an SSH
connection. (See Chapter 7: Services.)
The sysadmin user and users with who have full administrative rights have access to the complete
command set, while all other users have access to a reduced command set based on their
permissions.
Logging In
To log in to the SLC command line interface:
1. Do one of the following:
- With a serial terminal connection, power up, and when the command line displays, press
Enter.
- If the SLC console manager already has an IP address (assigned previously or assigned
by DHCP), Telnet (if Telnet has been enabled) or SSH to xx.xx.xx.xx (the IP address
in dot quad notation) and press Enter. The login prompt displays.
2. To login as the system administrator for setup and configuration:
a. Enter sysadmin as the user name and press Enter.
b. Enter PASS as the password and press Enter. The first time you log in, the Quick Setup
script runs automatically. Normally, the command prompt displays. (If you want to display
the Quick Setup script again, use the admin quicksetup command.)
Note: The system administrator may have changed the password using one of
the Quick Setup methods in the previous chapter.
3. To login any other user:

Lantronix SLC8 Specifications

General

Brand	Lantronix
Model	SLC8
Category	Server
Language	English