Lantronix SLC8 User Manual

13: Maintenance
SLC™ Console Manager User Guide 221
To display the acceptable range and the current reading from the internal temperature
sensor:
show temperature
To set the acceptable range for the internal temperature sensor (an SNMP trap is sent if the
temperature is outside of this range):
set temperature <one or more parameters>
Parameters:
low <Low Temperature in C. or F.>
high <High Temperature in C. or F.>
calibrate <Temperature Calibration in C. or F.|cancel>
Note: the calibration offset will be applied one hour after setting the value.
To display the acceptable range and the current reading from the internal temperature
sensor:
show temperature
To save the current SLC configuration to a selected location:
admin config save <Config Name> location
<local|ftp|sftp|nfs|cifs|usb|pccard>
[nfsdir <NFS Mounted Directory>] [usbport <U1>]
[pccardslot <upper|lower>]
[savesshkeys <enable|disable>] [savesslcert <enable|disable>]
[savescripts <enable|disable>]
To restore a saved configuration to the SLC:
admin config restore <Config Name> location
<local|ftp|sftp|nfs|cifs|usb|pccard>
[nfsdir <NFS Mounted Directory>] [usbport <U1>]
[pccardslot <upper|lower>]
[savesshkeys <enable|disable>] [savesslcert <enable|disable>]
[savescripts <enable|disable>]
[preserveconfig <Config Params to Preserve>]
To restore the SLC to factory default settings:
admin config factorydefaults [savesshkeys <enable|disable>]
[savesslcert <enable|disable>] [savescripts <enable|disable>]
[preserveconfig <Config Params to Preserve>]
<Config Params to Preserve> is a comma separated list of current configuration
parameters to retain after the config restore or factorydefaults:
nt - Networking ra - Remote Authentication
sv - Services dp - Device Ports
dt - Date/Time ub - USB / pc - PC Card
lu - Local Users

Lantronix SLC8 Specifications

General

Brand	Lantronix
Model	SLC8
Category	Server
Language	English