To Next Page

To Previous Page

13: Maintenance

SLC™ Console Manager User Guide 224

To update SLC firmware to a new revision:

Note: The firmware file should be accessible via the settings displayed by admin ftp

show. The SLC console manager automatically reboots after successful update.

[nfsdir <NFS Mounted Directory>] [usbport <U1>]

[pccardslot <upper|lower>]

To set the boot bank to be used at the next SLC unit reboot:

admin firmware bootbank <1|2>

Applies to dual-boot SLB/SLC units only

To list the current firmware revision:

admin firmware show [viewlog <enable|disable>]

Lists the current firmware revision, the boot bank status (for dual-boot SLB/SLC units),

and optionally displays the log containing details about firmware updates

To set the FTP/TFTP/SFTP server used for firmware updates and configuration save/

restore:

admin ftp server <IP Address or Hostname> [login <User Login>] [path

<Directory>]

To view FTP settings:

admin ftp show

To set the FTP server password and prevent it from being echoed:

admin ftp password

To restore the SLC console manager to factory default settings:

admin config factorydefaults [savesshkeys <enable|disable>] [savesslcert

<enable|disable>][preserveconfig <Config Params to Preserve>]

<Config Params to Preserve> is a comma-separated list of current configuration

parameters to retain after the config restore or factorydefaults:

nt – Networking ra - Remote Authentication

sv – Services dp – Device Ports

dt – Date/Time ub - USB

lu – Local Users

To restore a saved configuration to the SLC unit:

admin config restore <Config Name> location <default|ftp|sftp|nfs|cifs|>

[nfsdir <NFS Mounted Dir>] [ <>] [keepconfig <Config Params to Keep>]

[preserveconfig <Config Params to Prserve>]

Lantronix SLC8 User Manual

Other manuals for Lantronix SLC8