LeeBoy 8510b - Changing Engine Lubrication Oil and Filter

7-22 LeeBoy Model 8510B Conveyor Paver
Maintenance
Changing Engine Lubrication Oil
Filter
The engine lubrication oil lter must be changed when
the engine lubrication oil is changed.
Do not change the engine lubrication
oil when the engine and lubrication oil are hot.
Change when warm only. Hot oil can cause serious
injury.
Do not change the engine lubrication
oil lter with the engine running. Serious engine
damage, or failure, will occur.
With the engine “stopped” and lled with new engine
lubrication oil, proceed as follows:
1. Wipe the area around the engine lubrication oil lter
element and its mounting base, with a clean cloth.
2. Place a container under the lter element.
3. Use a lter removal wrench to loosen and remove
the lter element by turning it in a counterclockwise
(CCW) direction of rotation. Drain and discard the
removed lter element.
NOTE: Be sure the used rubber gasket is removed and
discarded with the lter element.
NOTE: Consider the environment when discarding
used oil and do so according to safe and lawful
practices.
4. Wipe the inside area of the lubrication oil lter head
using a clean lint free cloth.
5. Put clean engine lubrication oil on the rubber gasket
area of the new lter element. Fill the new lter
element with correct, new, and clean oil.
6. Install the new lter element onto the lter head.
Carefully tighten the lter element, by hand only.
NOTE: Tighten the lter element as directed on the lter
element, by the lter manufacturer.
Changing Engine Lubrication Oil
The engine lubrication oil must be changed according
to the interval given in the current Kubota Diesel engine
operator’s manual.
NOTE: The color of the engine lubrication oil can not be
used as an indication of the need for a engine
lubrication oil change. The use of an engine
lubrication oil “analysis service” is the only
alternate reason for not following the required
engine lubrication oil change schedule.
Do not change the engine lubrication
oil when the engine and lubrication oil are hot.
Change when warm only. Hot oil can cause serious
injury.
Do not change the engine lubrication
oil with the engine “running”. Serious engine damage,
or failure will occur. Clean the area around the
engine lubrication oil dipstick and oil ller cap before
removing the dipstick, or oil ller cap.
With the engine “stopped”, and the engine lubrication oil
is “warm”, proceed as follows:
1. Clean the area around the engine lubrication
oil drain plug found on the engine oil drain hose
located on the right side of the paver.
2. Place a container, having a capacity sufcient
to hold the drained oil, directly under the engine
lubrication oil drain plug.
3. Using hose and tting located on right-hand side of
paver, drain all of the engine lubrication oil into the
container.
4. Clean, install and carefully tighten the lubrication oil
drain plug.
Do not overtighten the drain plug.
5. Fill the engine with 15.0 qts (14.2 liters) of oil,
using the correct engine lubrication oil (see
Specications in Section 4).
6. Install the engine lubrication oil dipstick.
Do not start the engine before
changing the engine lubrication oil lter. Follow the
procedures given in this section and in the current
Kubota engine manual.
Return to
Last Viewed
Return to
Thumb Index