LeeBoy 8510b - General Information; Safety

6
LeeBoy Model 8510B Conveyor Paver 6-3
Operation
General Information
Before operating the LeeBoy Model 8510B Conveyor
Paver, you must read the following safety information
and review Safety in Section 2.
Operation Hazard! Never allow anyone
who is not properly trained to operate this paver.
Only authorized personnel who are properly trained
in the operation of the paver can operate the LeeBoy
Model 8510B Conveyor Paver.
Operation Hazard! Do not operate a
paver that requires repairs or scheduled
maintenance. Put an information tag on the
instrument panel that says “DO NOT OPERATE.”
Remove the key from the ignition switch. Repair all
damage at once and perform routine maintenance.
Minor damage can result in major system failure.
Operation Hazard! Never leave
machine operator station unattended with machine
in gear and/or in motion. Operator station is dened
as the platform area within arms reach of active
control steering box. Operator must remain in
operator’s station at all times when machine is in
gear and/or in motion. Before leaving machine
operator station, operator must return joysticks to
neutral position and move RUN/STOP switch to
STOP position.
Safety
• Verify there are no people, obstacles or other
equipment near or in the line of travel of the LeeBoy
Model 8510B Conveyor Paver, before starting the
engine sound horn.
• Work slowly in tight areas.
• Avoid steep hills if possible.
• Always look before changing the direction of travel.
• Always park the paver on solid, level ground in low
range. If this is not possible, always park the paver at a
right angle to the slope. Lower screed when parked.
• Use proper ags, barriers and warning devices,
especially when parking in areas of trafc.
• Do not run engine in a closed building for long periods
of time.
• Never open a valve to burner unless a ame is
present. Heat screed for no more than 15 minutes.
• Make sure all valves are closed before propane is
turned ON.
• Avoid leaving engine running without operator
present.
• Never work on the paver with the engine running.
• Do not change the engine governor settings.
• Always replace damaged or lost decals.
• Disconnect battery cables when working on the
electrical system or when welding on the unit.
• If battery needs a charge, be sure battery charger is
off when making connections.
• Be sure the correct battery polarity is observed
(negative (-) to negative (-) and positive (+) to positive
(+), when connecting a battery charger or jumper
cable. Never charge a frozen battery .
Return to
Last Viewed
Return to
Thumb Index